libvirt/tests/vmx2xmldata/vmx2xml-cdrom-scsi-raw-auto-detect.vmx

config.version = "8"
virtualHW.version = "4"
scsi0.present = "true"
scsi0:0.present = "true"
scsi0:0.deviceType = "cdrom-raw"
scsi0:0.fileName = "auto detect"
displayName = "test"
VMX: Add support for 'auto detect' fileNames VMWare Fusion 5 can set the CD-ROM's device name to be 'auto detect' when using the physical drive via 'cdrom-raw' device type. VMWare will then connect to first available host CD-ROM to the virtual machine upon start up according to VMWare documentation. If no device is available, it appears that the device will remain disconnected. To better model this a CD-ROM that is marked as "auto detect" when in the off state would be modeled as the following with this patch: <disk type='block' device='lun'> <source startupPolicy='optional'/> <target dev='hda' bus='ide'/> <address type='drive' controller='0' bus='0' target='0' unit='0'/> </disk> Once the domain transitions to the powered on state, libvirt can populate the remaining source data with what is connected, if anything. However future power cycles, the domain may not always start with that device attached. 2013-08-13 15:56:01 +00:00			`config.version = "8"`
			`virtualHW.version = "4"`
			`scsi0.present = "true"`
			`scsi0:0.present = "true"`
			`scsi0:0.deviceType = "cdrom-raw"`
			`scsi0:0.fileName = "auto detect"`
tests: vmx: Add <name> element for all domain XMLs <name> is mandatory for a domain XML. Add 'displayName' for all the test cases which were missing them so that <name> is parsed correctly. Signed-off-by: Peter Krempa <pkrempa@redhat.com> Reviewed-by: Pino Toscano <ptoscano@redhat.com> Reviewed-by: Michal Privoznik <mprivozn@redhat.com> 2020-10-07 17:00:04 +00:00			`displayName = "test"`