Our test data used a lot of different qemu binary paths and some
of them were based on downstream systems.
Note that there is one file where I had to add "accel=kvm" because
the qemuargv2xml code parses "/usr/bin/kvm" as virt type="kvm".
Signed-off-by: Pavel Hrdina <phrdina@redhat.com>
With unknown good reasons, the attribute "bus" of scsi device
address is always set to 0, same for attribute "target". (See
virDomainDiskDefAssignAddress).
Though we might need to change the algorithm to honor "bus"
and "target" too, that's a different issue. The address generator
for scsi host device in this patch just follows the unknown
good reasons, only considering the "controller" and "unit".
It walks through all scsi controllers and their units, to see
if the address $controller:0:0:$unit can be used (if not used
by any disk or scsi host device yet), if found one, it sits on
it, otherwise, it creates a new controller (actually the controller
is implicitly created by someone else), and sits on
$new_controller:0:0:0 instead.
