Since Xen 4.2 libxl expects device_model_override="/path" instead of
device_model="/path". Adjust the code to parse this as <emulator>.
While libxl also recognizes device_model_version="", this knob is not
required for libvirt. A runtime detection exists in libvirt to select
either "qemu-xen" or "qemu-xen-traditional".
Since qemu-xen-traditional is marked as supported just for stubdoms
there is no need to handle it.
Test data files with 'device_model' were adjusted to use
'device_model_override' instead.
Signed-off-by: Olaf Hering <olaf@aepfle.de>
Reviewed-by: Jim Fehlig <jfehlig@suse.com>
Some of the test configuration files in tests/xlconfigdata
use the old qemu-dm as the emulator. Many of the configuration
features tested (spice, rbd, multi-usb) are not even usable with
the old qemu. Change these files to use the new qemu-xen (also
known as qemu upstream) emulator.
Note: This change fixes xlconfigtest failures when the old
qemu is actually installed on the system. During device post
parse, the libxl driver attempts to invoke the emulator to
determine if it is the old or new qemu so it can properly set
video RAM defaults. With the old qemu installed, the default
video RAM was set differently than the expected value.
Changing all the test data files to use qemu-xen ensures
predictable results wrt default video RAM size.
Signed-off-by: Jim Fehlig <jfehlig@suse.com>
hap is enabled by default in xm and xl config and usually only
specified when it is desirable to disable hap (hap = 0). Change
the xm,xl <-> xml converter to behave similarly. I.e. only
produce 'hap = 0' when <hap state='off'/> and vice versa.
Signed-off-by: Jim Fehlig <jfehlig@suse.com>
The most formal form of xl disk configuration uses key=value
syntax to define each configuration item, e.g.
format=raw, vdev=xvda, access=rw, backendtype=phy, target=disksrc
Change the xl disk formatter to produce this syntax, which allows
target= to contain meta info needed to setup a network-based
disksrc (e.g. rbd, nbd, iscsi). For details on xl disk config
format, see $xen-src/docs/misc/xl-disk-configuration.txt
Update the disk config in the tests to use the formal syntax.
But add tests to ensure disks specified with the positional
parameter syntax are correctly converted to <disk> XML.
Signed-off-by: Jim Fehlig <jfehlig@suse.com>
Both xm and xl config have long supported specifying vif rate
limiting, e.g.
vif = [ 'mac=00:16:3E:74:3d:76,bridge=br0,rate=10MB/s' ]
Add support for mapping rate to and from <bandwidth> in the xenconfig
parser and formatter. rate is mapped to the required 'average' attribute
of the <outbound> element, e.g.
<interface type='bridge'>
...
<bandwidth>
<outbound average='10240'/>
</bandwidth>
</interface>
Also add a unit test to check the conversion logic.
Signed-off-by: Jim Fehlig <jfehlig@suse.com>
