Some of the test configuration files in tests/xlconfigdata
use the old qemu-dm as the emulator. Many of the configuration
features tested (spice, rbd, multi-usb) are not even usable with
the old qemu. Change these files to use the new qemu-xen (also
known as qemu upstream) emulator.
Note: This change fixes xlconfigtest failures when the old
qemu is actually installed on the system. During device post
parse, the libxl driver attempts to invoke the emulator to
determine if it is the old or new qemu so it can properly set
video RAM defaults. With the old qemu installed, the default
video RAM was set differently than the expected value.
Changing all the test data files to use qemu-xen ensures
predictable results wrt default video RAM size.
Signed-off-by: Jim Fehlig <jfehlig@suse.com>
hap is enabled by default in xm and xl config and usually only
specified when it is desirable to disable hap (hap = 0). Change
the xm,xl <-> xml converter to behave similarly. I.e. only
produce 'hap = 0' when <hap state='off'/> and vice versa.
Signed-off-by: Jim Fehlig <jfehlig@suse.com>
The target= setting in xl disk configuration can be used to encode
meta info that is meaningful to a backend. Leverage this fact to
support qdisk network disk types such as rbd. E.g. <disk> config
such as
<disk type='network' device='disk'>
<driver name='qemu' type='raw'/>
<source protocol='rbd' name='pool/image'>
<host name='mon1.example.org' port='6321'/>
<host name='mon2.example.org' port='6322'/>
<host name='mon3.example.org' port='6322'/>
</source>
<target dev='hdb' bus='ide'/>
<address type='drive' controller='0' bus='0' target='0' unit='1'/>
</disk>
can be converted to the following xl config (and vice versa)
disk = [ "format=raw,vdev=hdb,access=rw,backendtype=qdisk,
target=rbd:pool/image:auth_supported=none:mon_host=mon1.example.org\\:6321\\;mon2.example.org\\:6322\\;mon3.example.org\\:6322"
]
Note that in xl disk config, a literal backslash in target= must
be escaped with a backslash. Conversion of <auth> config is not
handled in this patch, but can be done in a follow-up patch.
Also add a test for the conversions.
Signed-off-by: Jim Fehlig <jfehlig@suse.com>
