Our test data used a lot of different qemu binary paths and some
of them were based on downstream systems.
Note that there is one file where I had to add "accel=kvm" because
the qemuargv2xml code parses "/usr/bin/kvm" as virt type="kvm".
Signed-off-by: Pavel Hrdina <phrdina@redhat.com>
We use the PreFormat callback for this. Many test cases need to be extended
to pass in proper qemuCaps flags so AssignAddresses doesn't throw errors.
One test case (pcie-root-port-too-many) is dropped, since it was meant
only for checking an error condition in qemuxml2argv, and one we add in
AssignAddresses it errors here too.
Long term I think AssignAddresses should be handled in qemu's PostParse
callback, but that's not entirely straightforward. Handling it here
means we can get the test suite churn over with.
The current code was a little bit odd. At first we've removed all
possible implicit input devices from domain definition to add them later
back if there was any graphics device defined while parsing XML
description. That's not all, while formating domain definition to XML
description we at first ignore any input devices with bus different to
USB and VIRTIO and few lines later we add implicit input devices to XML.
This seems to me as a lot of code for nothing. This patch may look
to be more complicated than original approach, but this is a preferred
way to modify/add driver specific stuff only in those drivers and not
deal with them in common parsing/formating functions.
The update is to add those implicit input devices into config XML to
follow the real HW configuration visible by guest OS.
There was also inconsistence between our behavior and QEMU's in the way,
that in QEMU there is no way how to disable those implicit input devices
for x86 architecture and they are available always, even without graphics
device. This applies also to XEN hypervisor. VZ driver already does its
part by putting correct implicit devices into live XML.
Signed-off-by: Pavel Hrdina <phrdina@redhat.com>
With unknown good reasons, the attribute "bus" of scsi device
address is always set to 0, same for attribute "target". (See
virDomainDiskDefAssignAddress).
Though we might need to change the algorithm to honor "bus"
and "target" too, that's a different issue. The address generator
for scsi host device in this patch just follows the unknown
good reasons, only considering the "controller" and "unit".
It walks through all scsi controllers and their units, to see
if the address $controller:0:0:$unit can be used (if not used
by any disk or scsi host device yet), if found one, it sits on
it, otherwise, it creates a new controller (actually the controller
is implicitly created by someone else), and sits on
$new_controller:0:0:0 instead.
