Opening raw network devices with the intent of passing those fds to
qemu is worth an audit point. This makes a multi-part audit: first,
we audit the device(s) that libvirt opens on behalf of the MAC address
of a to-be-created interface (which can independently succeed or
fail), then we audit whether qemu actually started the network device
with the same MAC (so searching backwards for successful audits with
the same MAC will show which fd(s) qemu is actually using). Note that
it is possible for the fd to be successfully opened but no attempt
made to pass the fd to qemu (for example, because intermediate
nwfilter operations failed) - no interface start audit will occur in
that case; so the audit for a successful opened fd does not imply
rights given to qemu unless there is a followup audit about the
attempt to start a new interface.
Likewise, when a network device is hot-unplugged, there is only one
audit message about the MAC being discontinued; again, searching back
to the earlier device open audits will show which fds that qemu quits
using (and yes, I checked via /proc/<qemu-pid>/fd that qemu _does_
close out the fds associated with an interface on hot-unplug). The
code would require much more refactoring to be able to definitively
state which device(s) were discontinued at that point, since we
currently don't record anywhere in the XML whether /dev/vhost-net was
opened for a given interface.
* src/qemu/qemu_audit.h (qemuAuditNetDevice): New prototype.
* src/qemu/qemu_audit.c (qemuAuditNetDevice): New function.
* src/qemu/qemu_command.h (qemuNetworkIfaceConnect)
(qemuPhysIfaceConnect, qemuOpenVhostNet): Adjust prototype.
* src/qemu/qemu_command.c (qemuNetworkIfaceConnect)
(qemuPhysIfaceConnect, qemuOpenVhostNet): Add audit points and
adjust parameters.
(qemuBuildCommandLine): Adjust caller.
* src/qemu/qemu_hotplug.c (qemuDomainAttachNetDevice): Likewise.
Device names can be manipulated, so it is better to also log
the major/minor device number corresponding to the cgroup ACL
changes that libvirt made. This required some refactoring
of the relatively new qemu cgroup audit code.
Also, qemuSetupChardevCgroup was only auditing on failure, not success.
* src/qemu/qemu_audit.h (qemuDomainCgroupAudit): Delete.
(qemuAuditCgroup, qemuAuditCgroupMajor, qemuAuditCgroupPath): New
prototypes.
* src/qemu/qemu_audit.c (qemuDomainCgroupAudit): Rename...
(qemuAuditCgroup): ...and drop a parameter.
(qemuAuditCgroupMajor, qemuAuditCgroupPath): New functions, to
allow listing device major/minor in audit.
(qemuAuditGetRdev): New helper function.
* src/qemu/qemu_driver.c (qemudDomainSaveFlag): Adjust callers.
* src/qemu/qemu_cgroup.c (qemuSetupDiskPathAllow)
(qemuSetupHostUsbDeviceCgroup, qemuSetupCgroup)
(qemuTeardownDiskPathDeny): Likewise.
(qemuSetupChardevCgroup): Likewise, fixing missing audit.
The QEMU driver file is far too large. Move all the audit
helper code out into a separate file. No functional change.
* src/qemu/qemu_audit.c, src/qemu/qemu_audit.h,
src/Makefile.am: Add audit helper file
* src/qemu/qemu_driver.c: Delete audit code
