qemu vhost-scsi devices map to XML roughly like:
<hostdev mode='subsystem' type='scsi_host'>
<source protocol='vhost' wwpn=X/>
</hostdev>
To support vhost-scsi-pci-{non-}traditional in qemu, we
need to to extend the SCSI Host hostdev XML to handle
model= value. This matches the XML model= format used
for mediated devices. This is just the domain_conf bits
and some XML test cases.
Use of virtio-X naming here does not match the hostdev
protocol=vhost nor does it match the qemu vhost-X device
naming, however it's more consistent with all other
model= names in this area, and also matches the
inconsistency of <vsock> devices which use model=virtio
but map to vhost-vsock on the qemu commandline
Reviewed-by: Andrea Bolognani <abologna@redhat.com>
Signed-off-by: Cole Robinson <crobinso@redhat.com>
Add new <disk> model values for virtio transitional devices. When
combined with bus='virtio':
* "virtio-transitional" maps to qemu "virtio-blk-pci-transitional"
* "virtio-non-transitional" maps to qemu "virtio-blk-pci-non-transitional"
Reviewed-by: Andrea Bolognani <abologna@redhat.com>
Signed-off-by: Cole Robinson <crobinso@redhat.com>
<disk> devices lack the model= attribute which is used by
most other device types. bus= mostly acts as one, but it
serves other purposes too like determing what target=
prefix to use, and for matching against controller type=
values.
Extending bus= to handle additional virtio transitional
devices will complicate apps lives, and it isn't a clean
mapping anyways. So let's bite the bullet and add a new
<disk model=X/> attribute, and wire up common handling
for virtio and virtio-{non-}transitional
Reviewed-by: Andrea Bolognani <abologna@redhat.com>
Signed-off-by: Cole Robinson <crobinso@redhat.com>
